![]() |
wow... i thought it was just me...
so this came up in discussion at my fd tonite, and it turns out its not just me that thought it was weird how recently more then before the volume of the commercials is much louder then the TV show itself... annoying!!
http://usgovinfo.about.com/b/2008/06...ial-volume.htm .... |
the newer tv's were supposed to put a stop to that.
|
yeah, they use a compressor to limit the total volume. but it's worse than that. i think commercials broadcast in monaural, or mono, mode, where just about everything else we listen to is some variant of stereo. if you've ever done the experiment where you used all of an amp's power to push only one signal, then hooked it up to do two or more, you know the difference in power. also, i find fewer instances of lower frequencies, which gives them more volume (since they don't have to push the heavier, lower frequency).
i would still like to have total control over the signal received and what to do with it. with the newer electronics appealing to the masses, more and more control is taken away so that you have to rely on what is produced by your electronics equipment - and then decide how to deal with it. there is no basis in fact for my point of view, just the way i see things. |
Quote:
You bring up a valid point. |
ya it sucks. some tvs do limit it.
|
Quote:
Quote:
|
I've been noticing it more lately due to having the fans on in the house and my PC fan makes a lot of noise, so I've needed to turn the tv up while watching shows. Then the commercials come on and they are ridiculously loud. I think they've reduced the volume on the regular shows as well.
|
I complained about this years ago. huzzah!
|
Quote:
|
Quote:
(bonus points if you can tell me the TV show that quote is from) it's been a problem, and with the TV makers adding in more post-processing, it will continue to be a problem. i prefer the raw signal, let me decide what to do with it. i've almost got the audiophile's dream system: everything comes in through my receiver first, then it goes to the end-user electronic item. like with the cable-TV signal, first it goes through my receiver, then on to the TV, so i can mute the TV's on-board electronics and process the audio signal how i like to hear it. of course there are things wrong with that type of setup, too, in that you are introducing "noise" into the cable's picture signal. not much, way less than the public's accepted .005% THD, but it's still there. much less aware of it now that the signal is digital. :mrgreen: |
Quote:
|
Quote:
|
well now that Billy Mays is gone, i really could care less about commercials
|
All times are GMT -5. The time now is 11:29 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.