Video from Atco 9/29
 

Here some video from tuesday night at atco (9/29) Still workin on the driver mod:lol:
No bottle for now!
http://www.youtube.com/watch?v=PypHx...eature=channel

nice runs! seem very consistent

on the 2nd to last run, I missed 3rd:banghead:.

Looks like it leaves hard, Rob.

You have a two step?

he likes to call it his rev limiter lol

As Ron would say, "its the factory 2 step" aka revlimiter:twisted:

Looks good Rob!

- Justin

nice runs! especially that last pass. the 2-3 and 3-4 shifts sounded realllly good. that wouldve been your 11.33 pass in better air! lol

Thanks, Hopefully next time out I can get some nice negative DA to run in!:nod:

Very nice runs. What were your 60 foots like and what are your mods?

his 60's are shown on the board after his launch, theyre all in the low-mid 1.6's :) he's H/C/I and full bolt ons with a 9inch under the car 3.89 gears i believe?

yo....I wanna go race so bad...I'm about to say F, this and just toss a set of 4.10s in the ten bolt weld the spiders and pray