aftermarket d.s six speed-9inch
 

looking for a 3.5 aftermarket driveshaft doesnt matter cromoly or aluminum,

PST makes a good one

i have a 3.5" aluminum shaft with no yoke, 1350 joints. It has a ring rubbed into the shaft from rubbing on the parking brake bracket. Its totally useable, but its there. Honestly its not very deep, you can catch it with you fingernail, I ended up picking up a 3" chromemoly one from JS to pickup some clearance. I "believe" its 120 wall, but i have it for quite a while and dont remember. bought it new off ebay. Not many miles on it though, maybe 5-6k? over the years. Has a new front joint.

I also have a heavyduty trans yoke with billet removable caps that i used with the shaft back when i still had a auto. It will fit a 700r4/t5/4l60/t56. Its stock length, used with a 9" moser rear and a stock 10bolt.

LMk if interested

shaft is free if pickup up, or gas money if you want to meet somewhere.

yoke is 100 bux if you want it
this is the yoke
http://www.iedls.com/Yokes/Custom-Quick-Release.asp

location?