Brake problems, pics inside...
 

So long story short, I did ssome suspension upgrading since all the bushings are 160K young. As you all know the one side had to be cut out to replace!! while I was under there I said, meh, might as well put new brakes, pads, rotors, etc. Here's a couple pics of the old setup to help you guys try to understand whats goign on.

http://i176.photobucket.com/albums/w.../brakes001.jpg

http://i176.photobucket.com/albums/w.../brakes004.jpg

http://i176.photobucket.com/albums/w.../brakes005.jpg


So I bought all the stuff, painted it, but there was a snag. Problem is it doesn't look like it's supposed to be on here in the first place. So now I'm at a loss here at what to do cause I'm not sure if I'm going to have problems. Here's what they look like.

http://i176.photobucket.com/albums/w.../brakes011.jpg

http://i176.photobucket.com/albums/w.../brakes012.jpg

http://i176.photobucket.com/albums/w.../brakes015.jpg

http://i176.photobucket.com/albums/w.../brakes014.jpg






Anybody know what they may fit? :D

ballin 22s yo!

So what's the problem? It looks like you went with the C5 or C6 upgrade? Which path did you choose, C5 or C6? I have C5 setup on my firechicken and my WS6 wheels clear, my ZR1 replica's clear, my OZ wheels clear and all are 17" wheels. I think (double check this) the C6 stuff requires 18" wheels.

I must be missing something?

Chris

So you don't like how the brakes look under the 17" wheel? Or?

Since they have "Corvette" embossed I would say C5 upgrade and not just the C5 rotors with brackets?

Just playing around with you guys. Yes I finally upgraded to C5 brakes. The calipers are so close that one of my inner wheel weights got knocked off so I had to go and get a slimmer one, and even that one had to have a smidgen of material taken off it the center to just clear. I haven't taken it out yet because I installed as well a 14.4:1 ratio rack from blueshark123, and badly needs an alignment. Also I have to finish putting in my lightweigt puhrods on the passenger side.

I've had all these parts for a few years, but I wanted to change all the ball joints and bushing before I installed so i can feel the steering and braking more accurately.

Looks real good man, more brakes is never a bad thing.