LS7 Clutch alum. flywheel or no
 

Ordering my clutch hopefully tonight.

Is it worth spending the extra 100$ for the weight savings of about 10lbs on the flywheel.

Car has never seen the track but I do drive it hard.

Is there anything else i should do while the trans is out ?
Any other parts i should get?

Already have the tick adjustable MC w/ remote bleed (thanks "V")
Ordering a GM slave, pilot and throwout bearing when I order the clutch

Anything else ? bolts?

Possible to do the rear main seal and oil pan gasket while I am in there?

if the rear main seal/ pan gasket isent leaking don't mess with it

Pan has some seapage, but the rear main isn't. Probably won't mess with it.
Thanks Charlie

As far as the clutch any advice on that ?

Seems like you got it pretty much covered. The tick master is tight to install.

Yeah I have been dreading doing that one lol. . .

Any tricks ?

Was going to use this as a rough guide
http://allirae.wordpress.com/2009/02...n-your-f-body/

I take the master off the brake booster then take the 4 nuts off inside that hold the booster to the firewall off... you wont get the booster out but it will slide a few inches out which helps a ton.

remote bleeder?

Ordered that with the MC sorrry

Speed Bleeder makes life easy

I saw that in the write up, was going to wait to see what the situation was like but I have faith now. Thanks again

Ordered everything except the throwout bearing which I did not see listed any where on tick or ws6store. So I will just make my way down to a dealer and pick one up.

Saved at least 80$ between prices on ws6store /w the free shipping compared to any other place I looked. A+

throwout bearing "should" come on the slave.

Ahh very good to know thanks

http://i44.photobucket.com/albums/f3...AwMDEuanBn.jpg

That's the slave..... Throwout bearing there ? I have no clue never saw anything like this

yea, the throwout bearing is on the end.

Here is a picture of a LS style slave pulled apart without the throwout bearing pictured.
http://www.torcavettes.com/tech/clutch/p100232.jpg
Here is a pic of my LS7 slave. The throwout bearing is there as well. The bearing in the package in the back, is the larger size CTS-V pilot bearing.
http://i32.photobucket.com/albums/d5...V/IMG_1802.jpg

Ah thank you,

And another thanks for the illustrations