some nova progress
 

http://i183.photobucket.com/albums/x...guy/nova24.jpg
http://i183.photobucket.com/albums/x...guy/nova25.jpg
http://i183.photobucket.com/albums/x...guy/nova26.jpg

finally got all the wiring done. I had run all new wires under the dash and figure out what went where in the engine bay.
http://i183.photobucket.com/albums/x...guy/nova27.jpg
line lock.don't mind the volts, the battery was pretty much dead
http://i183.photobucket.com/albums/x...guy/nova28.jpg
wiring my fuel sending unit for my fuel cell, that was fun:facepalm:

http://i183.photobucket.com/albums/x...guy/nova23.jpg

primed a fender too, just put it on somewhat so it wasnt laying around to get dented

Nice wire nut :lol:

Lol it's just a temp thing till I get my trans in and a carpet

Always good to see some progress, Jim!

Interesting picture here, :lol: :
http://i183.photobucket.com/albums/x...guy/nova28.jpg

Haha. I didn't want to take apart the dash to get to the fuel gauge. If there's a will there's a way!

looks good man.


takin it to bunker hill when its done :bertstare:

http://i183.photobucket.com/albums/x...guy/nova27.jpg

Is that a wire nut??

Nice!

See above. It's temporary.

cool, I missed that scrolling through the pics. carry on. nice progress!

i don't participate in things like that

thanks guys, hopefully tomorrow i will be stripping the hood and driver fender.

i use wire nuts because its a lot easier to twist wires together with them, i just wanted to run the wires to the switch and made sure it worked before i connected it. i hate getting stabbed with that damn wire when twisting them together lol

update
 

http://i183.photobucket.com/albums/x...aguy/novab.jpg
http://i183.photobucket.com/albums/x...guy/novacc.jpg

and wet sanded

http://i183.photobucket.com/albums/x...aguy/novaa.jpg

tomorrow will be the driver fender and cowl panel(weather permitting)

Coming along awesome man!

Love it!

Looking good so far. Any estimated date of completion?

Thanks! Well it should be running by February and I have to wait for warmer weather to strip the rest of the car and prime it. I need to finish fuel lines, bleed the brakes and put my EWP and carb on and properly mount the plug wires

http://i183.photobucket.com/albums/x...ps82736b60.jpg

Hydraulics mounted for the t56

http://i183.photobucket.com/albums/x...ps1a926690.jpg

Engine is in, not the 406. A 350 with 400 heads, comp cams 280h cam team g intake and the carb will be going on hopefully tomorr

the nova looks great

Thanks

http://i183.photobucket.com/albums/x...ps9e76a186.jpg

And 406 top end ;)

http://i183.photobucket.com/albums/x...ps736ead1f.jpg

Purchased the carbs from mark68. Great guy with an awesome car!

Lookin real good!

Thanks! Hopefully it will run soon lol

it looks great how long till its ready

Engine bay is looking gooood

Thanks man!

Progress. Car is in the air awaiting the t56 and waterpump is on. I've dropped and installed 2 t56s on my back but this will be the first on 3/4 clean stone lol

http://i183.photobucket.com/albums/x...ps406a0022.jpg

http://i183.photobucket.com/albums/x...ps83b52caa.jpg

My back hurt just reading that