1993 S10 Roller setup for SBC
 

Single cab short bed 93 S10 set up for a SBC/any 3 speed/4 speed auto trans except the TH400. Paint is alright, probably wouldn't look bad with a good wet sand. Defiantly not perfect but looks nice from 10 feet away. Interior is clean, I have the bolts to put it together.

Will throw in a 8 cylinder radiator with a electric fan, cross member, motor mounts and a set of shorty headers. Truck has toneau covers and an open dif 3.73 10 bolt. Interior is pretty clean minus a sagging headliner. Wiring in glove box for a head unit. Speakers are very clear. Has aftermarket gauge cluster, new fuel lines, electric fuel pump w/ built in regulator and a rear roll pan. Truck has ZERO RUST or body damage.

Ratchet shifter, motor and transmission are not included. Truck weighed roughly 2,750lbs with a th350 and cast iron heads. Cammed 350 with vortec heads and it was way faster than my bolt on/gears LT1 Z28 by a long shot.

$1,000 OBO. Open to trades for SBC/BBC (really looking for a 454+ ci motor or short block) parts, 69 camaro wheels/tires/parts and maybe some other stuff. LMK what you have.
Have a set of long tubes, 4.10s and a GM gov lock that can be purchased for an additional fee.

http://desmond.imageshack.us/Himg221...pg&res=landing
http://desmond.imageshack.us/Himg28/...pg&res=landing
http://desmond.imageshack.us/Himg41/...pg&res=landing
http://desmond.imageshack.us/Himg844...pg&res=landing
http://desmond.imageshack.us/Himg405...pg&res=landing

Want to sell the govlock seperately? Pm me if so