1993 Z28: Parting out(plus more)
 

I have a 1993 z28 that I'm starting to part out.
Feel free to make offers and ask about anything not listed.
However, if its not listed, I probably don't have it or its damaged.

Car was a lt1/t56 in the process of becoming a lt1/46l0e.
All t56 stuff is gone.
Car is green/grey Metallic, a 93/94 only color
Front bumper is aftermarket and paint is flaking due to poor prep whenever it was painted.

(all body parts are for 93-97 and main dash shell is grey like 93s only)

In the next few days I'll also add parts from the 94 Trans Am I'm parting out too. As well as other parts I have laying around.

Right Fender: 75
Left fender: 75
Driver doors: 50
pass door: 20
front bumper brackets: 40
Headliner(hardtop): 100
a pillar trim(hardtop): 25
Dash shell: 80
Hvac controls: 15
Front bumper: 25
radio pod: 40
Front impact bumper: 80
cluster bezel: 20
Hood vents : 15
steering column: 100
Headlights with bar: 125
master brake cylinder: 25
Hatch 80
abs block: 20
Rear bumper: 50
Interior door panels: 100
Gauge cluster : 40
Seats: 100
Center console 50
Shifter plate auto: 40
Flowmaster exhaust: 80
Gas tank: 40
Taillights(need to be sealed): 15
headlight switch: 20
Rear filler panel: 40
Interior sail panels: 25
Interior trunk panels: 25
Kick panels: 20
radiator: 50
Trunk carpet: 10
cooling fans: 50
Carpet: 80
k member : 75
front brakes: 40
trans crossmember 93-97: 15
poly transmission mount NEW: 15
97+ z28 wheels(2 tires good): 220
Disc brake rear: 200
windshield: 125
wiper arm assembly: 80
auto shifter: 25
driver under dash panel: 20
fuse box door/cover: 5
front chassis wiring harness: 50
power window harness: 40
seat belts: 75
a/c heater box: 50
blower fan: 15
rear side markers: 5
front turn signals: 15
rear bumper wiring harness: 10
washer reservoir: 5
sill plates: 5
done light: 5
fuel lines: 50
brake lines: 50
stock rear LCAs: 10
stock TQ arm 10
stock panhard: 10
ebrake cables: 20
brake booster: 10
brake/gas pedal(auto): 15
hood hinges and latch: 15
taillight harness: 15
weatherstripping: 50
a/c condensor: 10
sway bar f: 15
sway bar r: 15
rear springs: 25
front shocks/springs: 30
trans tunnel cutout: 30
cruise control box: 10
door hinges R: 15
door hinges L: 15
fog lights: 75
rear view mirror: 5
radiator shroud 10
driveshaft(steel): 20
flowmaster catback(dual-dual tips): 100
c5 z06 wheels pr: 100
interior chassis wiring: 30
lowering springs set: 150
driver 1/4 panel: 250
pass 1/4 panel: 250


http://i32.photobucket.com/albums/d5...psfb679723.jpg
http://i32.photobucket.com/albums/d5...ps7759e0bc.jpg
http://i32.photobucket.com/albums/d5...ps72604fba.jpg
http://i32.photobucket.com/albums/d5...ps584bbad5.jpg
http://i32.photobucket.com/albums/d5...psaeffb6fc.jpg


http://i32.photobucket.com/albums/d5...pscedc7cab.jpg
http://i32.photobucket.com/albums/d5...psa854cc79.jpg
http://i32.photobucket.com/albums/d5...pscd653a6b.jpg



This is the one of 2 flowmaster catbacks I have. The front flange is rusting out and would need some attention
dual dual chrome tips, Was on a 94 Trans am. I'd cut just the tips off for $80.

http://i32.photobucket.com/albums/d5...psf735e692.jpg
http://i32.photobucket.com/albums/d5...ps12e2bcdd.jpg
http://i32.photobucket.com/albums/d5...ps50db4500.jpg

Are you sure that front bumper is aftermarket? There's no GM stampings or part number on the flap area?

I haven't really looked but based on the fit by the headlights and fender it didn't look right. It may have been a new GM one but i wont know till i really start pulling it apart. Either way its not mint and would need some attention and fully sanded down.

Ok let me know if you come up with anything. Usually aftermarket ones don't have the raised bow tie molded in (licensing bs) so it had me curious. I'm not concerned with bodywork.

Single or quad tips on the magnaflow?

c5z06 wheels available?
not pitted?
comes with tires?

quad i believe. if you can find any pics of the SOM 94 trans am i had, that's the exhaust .

wsex, responses through texts. lol. only 2 and chrome is peeling/pitted

4L60 shift linkage and bracket to mount to pan?

Labeling/Selling bolts? :lol:

yes, i got a pic to send you of the v6 4l60e. It still has the shifter cable on it so i just need to know exactly which parts you need.


Mike, come over with a list and we'll go from one car to another and bag and tag everything you need.

are these OEM? do they same speedline or alcoa on the back? 17 or 18 "? pics?

they are pitted and chrome is peeling. ill check to see if they say anything. they are 17s.

All 4 z06 wheels for 100 I'm interested and do you still have the mirrors ??

no. pair. condition was previously stated

mirrors were never listed nor are even on the car in the pictures.

lol ok didnt know if u still had the mirrors

Do you have both horns for sale?

i do have several sets of horns available, however I will be away for the weekend, so i cant get you any pics or exact info just yet

Still got the shift cable hookup?

do you have the engine for sale?

nope