Shorty headers/y-pipe and 3" flowmaster catback for 3rd gen
 

I have a set of Summit Racing shorty headers/ Y-pipe for 1982-92 Camaro/Firebird. They are
1 1/2" primaries and 2.5"" collectors. They are in good shape and are only about 2 yrs old. The Y-pipe is homemade 2.25" going into 3". Asking $100


Catback:


I have a fairly new (approximately 2 yrs old) Flowmaster 3" American Thunder cat back exhaust system for 82-92 Camaro/ Firebird. The exhaust has a dent in the pipe up toward the front of the exhaust. Also the previous owner squashed the exhaust into an oval shape where the pipe goes over the rear axle. Finally it was also cut and re-welded in the same area right over the rear axle. I have no idea why this stuff was done. It works and doesn't leak but not pretty. Condition of pipes are very good no rust. Muffler and tailpipes are in good shape and were not modified. Asking $100



located in Hatboro, Pa



http://i272.photobucket.com/albums/j...psh50hr0pm.jpg

http://i272.photobucket.com/albums/j...psedday8ef.jpg

http://i272.photobucket.com/albums/j...psftnhmlak.jpg

http://i272.photobucket.com/albums/j...psyjjpdazc.jpg

http://i272.photobucket.com/albums/j...psz9ffsxw8.jpg

http://i272.photobucket.com/albums/j...psqgqpetm9.jpg

http://i272.photobucket.com/albums/j...pshasllp32.jpg

ttt