ZZ3 Crate motor
 

I have a ZZ3 Crate motor (GM Performance Parts) for sale. It was in a Camaro project I picked up. Motor is in good mechanical/ running condition. It has a Edelbrock Performer intake manifold, Aluminum Corvette heads (casting #113) and Crane gold 1.6 roller rocker arms. Motor has approximately 25k miles on it. Here are the specs:


PN: 10185072

Displacement: 350 cubic inches (5.7L)
Horsepower: 345 at 5200 rpm
Torque: 387 lb-ft at 3250 rpm
Max RPM: 5800
Compression ratio: 9.8:1
Bore & Stroke: 4.00" x 3.48"
Pistons: Cast hypereutectic aluminum
Rods: 1053 forged steel "pink"
Heads: Cast aluminum, angled plugs, 58cc
Head specs: 1.94"/1.50"
Camshaft: Hydraulic roller tappet
Cam specs: 208/221 .474"/.510" 308/316 (advertised)
Idle: 750 rpm


Complete motor minus carb and distributor $1500

Short block $800

Aluminum heads $500

Edelbrock Performer intake $65

Crane Gold roller rocker arms 1.6 ratio (3/8") $175

Located in Hatboro, Pa

http://i272.photobucket.com/albums/j...psbt0hvk9i.jpg
http://i272.photobucket.com/albums/j...psgz28hkzh.jpg
http://i272.photobucket.com/albums/j...psd8my4hid.jpg
http://i272.photobucket.com/albums/j...pshi4hk5zj.jpg

http://i272.photobucket.com/albums/j...psq2g8kb1g.jpg
http://i272.photobucket.com/albums/j...psjjrd3qcb.jpg
http://i272.photobucket.com/albums/j...pssfx25xpt.jpg
http://i272.photobucket.com/albums/j...pslsuy3qgq.jpg
http://i272.photobucket.com/albums/j...pssds4lqow.jpg
http://i272.photobucket.com/albums/j...psms5rtxny.jpg

http://i272.photobucket.com/albums/j...pscdvm9bi8.jpg
http://i272.photobucket.com/albums/j...ps0zjvpy6b.jpg

http://i272.photobucket.com/albums/j...psnsu98iph.jpg
http://i272.photobucket.com/albums/j...psc1a8xbdz.jpg

Opened up bottom end and found the following


1) It has a Scat crank in it

2) motor is bored .030 over

3) It os a 4 bolt main block

May trade for a project car that I can part out.

Another update motor is a 383 not a 350. It has a Scat stroker crank in it.

Sold!!