Yet another problem with the Firehawk
 

I did the whole "warping" thing to my rotors, from messin around too much on the expressway with my friends, so I'm at work now and bored as ****, so I figured I would go ahead and resurface the rotors just to stop the vibration in the steering wheel when braking, at least until I get the new brakes (seems like a good deal going on over at LS1tech.com). Well all is fine, pulled the rotors off in 15 minutes max, walk down to my shop start going and Q@#$&!!!!! The rotor comes loose and "wobbles" putting HUGE gouges into it. It took alot of time to fix that mess, but seems to be going good now. Hopefully when I get the micrometer on it, it's not too thin...Well back to working on the rotors, almost done....

Later
Dave

sorry to hear about the bad luck. at least you have access to equipment to correct the situation.

later
tim

Well I finally finished, everything came out fine, I didn't bother to hit the the rotors with the micrometer...I'll just have to get new rotors really really soon....And remember to not hit the brakes too hard for a while...

Later
Dave