Today's Posts Mark Forums Read Calendar
Go Back   NJFBOA - Home of New Jersey's Camaros and Firebirds > Search Forums
Reload this Page Search Results
Home Register FAQ Today's Posts Search

Notices


Page 5 of 20 1234 5 678915 Last »
Showing results 101 to 125 of 500
Search took 0.01 seconds; generated 40 minute(s) ago. Search: Posts Made By: //<86TA>\\
Forum: Wanted To Buy - Automotive 04-01-2012, 12:18 PM
Replies: 2
Views: 3,236
Posted By //<86TA>\\
98-02 spare

looking for a 98-02 spare. Cheaper the better:mrgreen:

-Phil
Forum: Wanted To Buy - Automotive 03-26-2012, 09:11 PM
Replies: 6
Views: 4,664
Posted By //<86TA>\\
there is a VSS on the trans, no wheel sensors. ...

there is a VSS on the trans, no wheel sensors. the 700r4 is not electronically controlled, so the vss has nothing to do with its shifting

there is a TV (throttle valve) cable attached with the...
Forum: Electrical and Wiring 03-23-2012, 08:06 PM
Replies: 25
Views: 19,058
Posted By //<86TA>\\
yes, thats also possible. If its bad enough, it...

yes, thats also possible. If its bad enough, it could cause this. I suppose that will depend on what happens when you switch wires.

is the wire all visible or is it run in the frame or...
Forum: Electrical and Wiring 03-23-2012, 07:42 PM
Replies: 25
Views: 19,058
Posted By //<86TA>\\
yes, but only with the lamp installed, so you...

yes, but only with the lamp installed, so you need to test with the lamp in. With no lamp, there is an open int he circut and no current will flow, so the restriction will not be evident


that...
Forum: Electrical and Wiring 03-23-2012, 07:28 PM
Replies: 25
Views: 19,058
Posted By //<86TA>\\
i also agree with Paul V and sbmxrdr. Try...

i also agree with Paul V and sbmxrdr. Try swapping the wires, see what happens. If it works after switching wires, its a problem with the controller, obviously. If it doesnt change anything, just...
Forum: West Central Jersey 03-22-2012, 09:18 PM
Replies: 61
Views: 15,477
Posted By //<86TA>\\
i'd love to go, but i dont think i can get off...

i'd love to go, but i dont think i can get off work. I'll have to see
Forum: Brake, Chassis and Suspension Tech 03-18-2012, 05:30 PM
Replies: 35
Views: 22,261
Posted By //<86TA>\\
you doing this in a garage or outside in the...

you doing this in a garage or outside in the driveway?
Forum: Brake, Chassis and Suspension Tech 03-15-2012, 07:48 PM
Replies: 35
Views: 22,261
Posted By //<86TA>\\
something is not right then. the arm should...

something is not right then. the arm should slide freely in and out, if its really that hard, something is wrong. Is this the original bushing and torque arm? there are 2 different bushings and...
Forum: Brake, Chassis and Suspension Tech 03-15-2012, 05:05 PM
Replies: 35
Views: 22,261
Posted By //<86TA>\\
is the arm bolted to the axle? if it is, it...

is the arm bolted to the axle? if it is, it shouldnt be. If you support the back of the car, and let the rear hang with the floor jack under it, you can raise and lower the axle to change the angle...
Forum: West Central Jersey 03-15-2012, 05:02 PM
Replies: 52
Views: 16,458
Posted By //<86TA>\\
you all suck! looks like me, bear, zorns,...

you all suck!

looks like me, bear, zorns, and maybe bigshow?
Forum: West Central Jersey 03-14-2012, 08:18 PM
Replies: 52
Views: 16,458
Posted By //<86TA>\\
so who is actually going to this?

so who is actually going to this?
Forum: Brake, Chassis and Suspension Tech 03-11-2012, 07:15 PM
Replies: 5
Views: 7,976
Posted By //<86TA>\\
if you raise or lower the axle, the angle will...

if you raise or lower the axle, the angle will change a little and may help. Unless the issue is with the holes in the TA itself.
Forum: Transmission and Driveline 03-10-2012, 05:18 PM
Replies: 35
Views: 17,727
Posted By //<86TA>\\
not as much as the tunnel fitment issues, lol. ...

not as much as the tunnel fitment issues, lol. BUt yes, without changing parts, not sure what ones, they dont like to shift over 6500 rpm.

its still cheaper to find a low mile 1lt t56 and swap it...
Forum: West Central Jersey 03-10-2012, 04:32 PM
Replies: 52
Views: 16,458
Posted By //<86TA>\\
most people who regularly attend have not been...

most people who regularly attend have not been available for 2nd tuesday, so they were shuffled a bit so more people can come.
Forum: Engine / Power / Tuning 03-07-2012, 07:07 PM
Replies: 13
Views: 5,751
Posted By //<86TA>\\
http://www.jbp-pontiac.com/ i will also say...

http://www.jbp-pontiac.com/

i will also say stick with a sbc or more common engine. the cost of being "different" is really not worth it.
Forum: Engine / Power / Tuning 03-06-2012, 06:28 PM
Replies: 111
Views: 72,008
Posted By //<86TA>\\
the 3rd gen tank has no direct vent line, it has...

the 3rd gen tank has no direct vent line, it has a vacuum break line that goes to the back of the rear seat area.

pulling the tank is not too bad, just need a second set of hands and be DAMN SURE...
Forum: Transmission and Driveline 03-05-2012, 08:25 PM
Replies: 35
Views: 17,727
Posted By //<86TA>\\
the 3rd gen zf bellhousing from the firehawk will...

the 3rd gen zf bellhousing from the firehawk will cost a fortune, more than most 3rd gens sell for, thats if you ever find one for sale, which you wont.

Can you use the vett bellhousing? i dont...
Forum: West Central Jersey 03-05-2012, 06:25 PM
Replies: 52
Views: 16,458
Posted By //<86TA>\\
seems like its thursday then im still in for...

seems like its thursday then

im still in for either place.
Forum: West Central Jersey 03-04-2012, 03:29 PM
Replies: 52
Views: 16,458
Posted By //<86TA>\\
nah, we usually forget about this until the...

nah, we usually forget about this until the monday before, then mad rush a meet, lol

Killarneys in hamilton? Or you guys wanna do tortugas mexican village maybe? i dont think we have been to...
Forum: Multimedia 03-04-2012, 02:59 PM
Replies: 1
Views: 2,029
Posted By //<86TA>\\
Been around for years. Saw it at SEMA 2010,...

Been around for years.

Saw it at SEMA 2010, and at the optima race the same year. badass car. I have pics of it somewhere after a "offroading" incident at the race.... the owner/driver is a bit...
Forum: Engine / Power / Tuning 02-24-2012, 05:32 PM
Replies: 111
Views: 72,008
Posted By //<86TA>\\
That idle screw may be loose and vibrated out.

That idle screw may be loose and vibrated out.
Forum: Appearance 02-15-2012, 05:12 PM
Replies: 27
Views: 18,426
Posted By //<86TA>\\
this ...

this
http://www.summitracing.com/parts/APR-400EU/

they make manual ones that are a heck of a lot cheaper too. I ahve them on both my cars.

links in above 2 posts.....

up
...
Forum: Engine / Power / Tuning 02-15-2012, 04:59 PM
Replies: 111
Views: 72,008
Posted By //<86TA>\\
the helper pump was for vapor lock issues i...

the helper pump was for vapor lock issues i believe.

if the car is to stay carbed, the tank needs to be removed, whatever pump setup is in there needs to be removed and bypassed. After that, a...
Forum: The Early Years 67-92 02-14-2012, 08:52 PM
Replies: 86
Views: 95,462
Posted By //<86TA>\\
hey check this **** out, the car HAS a mechanical...

hey check this **** out, the car HAS a mechanical pump, you can see it on the block in the pics! how many fuel pumps does this car have, lol.... what is the 8th digit of the vin? I see z28...
Forum: The Early Years 67-92 02-14-2012, 08:50 PM
Replies: 86
Views: 95,462
Posted By //<86TA>\\
with a good regulator you can do about anything. ...

with a good regulator you can do about anything. my a1000 pump puts out ~45 psi and i have a steady 6.5 psi after my regulator.
Showing results 101 to 125 of 500
Page 5 of 20 1234 5 678915 Last »

 
Forum Jump
» Sponsor List














All times are GMT -5. The time now is 02:46 AM.

Contact Us - New Jersey F-Body Owners Association - Home of New Jersey's Camaros and Firebirds - Archive - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2026, vBulletin Solutions Inc.