Today's Posts Mark Forums Read Calendar
Go Back   NJFBOA - Home of New Jersey's Camaros and Firebirds > Search Forums
Reload this Page Search Results
Home Register FAQ Search Today's Posts Mark Forums Read

Notices


Showing results 1 to 7 of 7
Search took 0.00 seconds. Search: Posts Made By: transmaro93
Forum: Restorations, Fabrication, Tool and Shop Tech 03-13-2013, 06:05 PM
Replies: 47
Views: 11,005
Posted By transmaro93
lol... so why cant he do what i said yesterday...

lol... so why cant he do what i said yesterday and just cut a small hole from the inside and a larger on in that frame peice... if it can be unplugged once trans is lowered a little... chances are...
Forum: Restorations, Fabrication, Tool and Shop Tech 03-13-2013, 05:54 PM
Replies: 47
Views: 11,005
Posted By transmaro93
ok.. but is it not a bigger pain the in the ass...

ok.. but is it not a bigger pain the in the ass to remove interior every time you have to disconnect that plug. if your looking in the long run to make life easier should the trans have to come out...
Forum: Restorations, Fabrication, Tool and Shop Tech 03-13-2013, 05:13 PM
Replies: 47
Views: 11,005
Posted By transmaro93
ok even with a decent sized hole cut in that...

ok even with a decent sized hole cut in that frame peice you wont be able to sneak your fingers in there to attach and detach the harness from under the car? ... if this is so what if you "notch"...
Forum: Restorations, Fabrication, Tool and Shop Tech 03-12-2013, 06:18 PM
Replies: 47
Views: 11,005
Posted By transmaro93
was thinking more about this... is there an...

was thinking more about this... is there an actual clearance issue on the trans half of the connector or just a clearance issue when the harness end is plugged in? was thinking today to do it (imo)...
Forum: Restorations, Fabrication, Tool and Shop Tech 03-11-2013, 08:33 PM
Replies: 47
Views: 11,005
Posted By transmaro93
if you wanna cut and weld a plate or somthing...

if you wanna cut and weld a plate or somthing that is doable to. i can help ya with that if you want to go that route. but your car is at your house and not drivable. assuming you dont have a welder...
Forum: Restorations, Fabrication, Tool and Shop Tech 03-11-2013, 08:22 PM
Replies: 47
Views: 11,005
Posted By transmaro93
lol i know thats where it is but its hard to tell...

lol i know thats where it is but its hard to tell in pic how curved it is. i dont see why you can just cut a nice hole with a hole saw and use those grommets. if that ring is metal you can bang it...
Forum: Restorations, Fabrication, Tool and Shop Tech 03-11-2013, 08:12 PM
Replies: 47
Views: 11,005
Posted By transmaro93
how curved is that area? those grommets are...

how curved is that area? those grommets are pretty cool. id say cut it with a holesaw put the grommet in and just bang it into place and screw it in with the supplied holes. If its not going to be...
Showing results 1 to 7 of 7

 
Forum Jump
» Sponsor List














All times are GMT -5. The time now is 03:27 PM.

Contact Us - New Jersey F-Body Owners Association - Home of New Jersey's Camaros and Firebirds - Archive - Top

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.