Today's Posts Mark Forums Read Calendar
Go Back   NJFBOA - Home of New Jersey's Camaros and Firebirds > Search Forums

Notices


Showing results 1 to 25 of 500
Search took 0.27 seconds.
Search: Posts Made By: TaKid455
Forum: Engine / Power / Tuning 07-31-2020, 07:22 AM
Replies: 167
Views: 11,322
Posted By TaKid455
2nd the II Much stuff. Nice piece. Also used for...

2nd the II Much stuff. Nice piece. Also used for Diff venting.

While I have heard of return style system issues, I haven't run into any. For simplicity, I build them with the return back by the...
Forum: The Later Years 93-present 07-21-2020, 08:04 PM
Replies: 306
Views: 30,127
Posted By TaKid455
Believe this is the trans temp sensor: ACDELCO...

Believe this is the trans temp sensor:
ACDELCO 12458118


Good to see it all back together...again. The Monster issue was strange as in static conditions everything was smooth. It was very nice...
Forum: Wanted To Buy - Automotive 07-20-2020, 08:38 AM
Replies: 7
Views: 218
Posted By TaKid455
That is just a hair bigger displacement. Any meat...

That is just a hair bigger displacement. Any meat left on those sleeves at that bore dia? Say it get redone down the road, can you safely go 20 or 30 over?

Any filler in the block? Decked? Main...
Forum: Wanted To Buy - Automotive 07-19-2020, 08:45 AM
Replies: 7
Views: 218
Posted By TaKid455
I'll keep in mind. Being this will be a street...

I'll keep in mind. Being this will be a street car, I rather full cooling capacity. Yes, I know it can be done and has been done. Oil temps would be the concern more so over coolant. Was the machine...
Forum: Wanted To Buy - Automotive 07-17-2020, 09:49 PM
Replies: 7
Views: 218
Posted By TaKid455
WTB LS2 6.0 Al block/ engine

Throwing the net out and seeing if anyone has an LS2 block. LS1 & 3 also considered. Ultimately looking to go the 408 or 416 route.
PM or reply
Forum: Engine / Power / Tuning 07-03-2020, 07:38 AM
Replies: 167
Views: 11,322
Posted By TaKid455
Pick up the phone: ...

Pick up the phone:
https://sweetmfg.biz/home.php?cat=27&page=1

Used their stuff in the past. Works.
Forum: Welcome / Introduction 05-10-2020, 08:52 PM
Replies: 10
Views: 807
Posted By TaKid455
Went with a 4 post for the house garage. Its main...

Went with a 4 post for the house garage. Its main intent is to add vehicle storage capacity. Prefer the 4 post as it keeps the suspension loaded and don't have to worry about body flex. I set it up...
Forum: Engine / Power / Tuning 04-22-2020, 08:33 PM
Replies: 167
Views: 11,322
Posted By TaKid455
Prewording - by no means am I proclaiming to be...

Prewording - by no means am I proclaiming to be an expert in this field or advising fully what's required or involved. Instead, I am relaying information I have been informed, researched, & studied...
Forum: Engine / Power / Tuning 04-22-2020, 07:12 AM
Replies: 167
Views: 11,322
Posted By TaKid455
Can should be higher. Vapor travels up. The...

Can should be higher. Vapor travels up. The downward path could cause an air pocket. Might be stretching it there.

Monitor the black crud. Keep on trucking. First couple oil changes will have...
Forum: Engine / Power / Tuning 04-20-2020, 08:31 PM
Replies: 167
Views: 11,322
Posted By TaKid455
A tip on the Knock sensor, TPI cars had them on...

A tip on the Knock sensor, TPI cars had them on the RH side by the engine mount. (ACDELCO 21396 ) While it is a possibility, you would need to know the sensor's specifics and also that your block is...
Forum: Engine / Power / Tuning 03-10-2020, 08:11 PM
Replies: 167
Views: 11,322
Posted By TaKid455
Heard you guys from the house. Great weekend for...

Heard you guys from the house. Great weekend for an opening day. Congrats on the no break day.

If you send me the datalogs, I'll take a peak at them and see if anything seems out of place.
Forum: Engine / Power / Tuning 02-11-2020, 08:21 PM
Replies: 167
Views: 11,322
Posted By TaKid455
A tid bit on the OPS. Use one from a 68 GTO....

A tid bit on the OPS. Use one from a 68 GTO. PS157. Fits other applications as well. Reads same ohms as the PS155. 0-80 psi. Same thing just a shorter housing. Fits under HEI. Downside it cost a...
Forum: General Tech 12-22-2019, 02:40 PM
Replies: 142
Views: 27,177
Posted By TaKid455
1 GA should be fine but we always run 1/0. Always...

1 GA should be fine but we always run 1/0. Always a power & ground front to rear along with the rear chassis ground. The diagram has a ground going from L - R on the block. Sure but not necessary...
Forum: Wanted To Buy - Automotive 12-03-2019, 09:00 PM
Replies: 5
Views: 435
Posted By TaKid455
Have customer that is selling his ST-10. Fress...

Have customer that is selling his ST-10. Fress rebuild. Went T56 so not going to use it. Belive he had 1200 into it, I can find out what he wants if interested. Wont be 600, I know that.
Forum: General Tech 11-07-2019, 06:32 AM
Replies: 142
Views: 27,177
Posted By TaKid455
will I need a vaccum pump for brake system? -...

will I need a vaccum pump for brake system? - This is relative to cam. Engine builder will answer this. With today's advancements and your power level, I'd push to run it without. Less crap. I would...
Forum: Welcome / Introduction 10-28-2019, 08:28 PM
Replies: 10
Views: 3,059
Posted By TaKid455
Welcome. Parked next to you at the Flemingtion...

Welcome. Parked next to you at the Flemingtion cruise night along with my friend in his 78 TA also. Nice car you have and you keep it in great condition! Keep an eye out for the car you want, itll...
Forum: NJFBOA Events 10-18-2019, 08:24 PM
Replies: 40
Views: 6,059
Posted By TaKid455
Looks like I'll be heading down with a local...

Looks like I'll be heading down with a local group.
Forum: Engine / Power / Tuning 10-10-2019, 12:37 PM
Replies: 8
Views: 2,400
Posted By TaKid455
saw you mentioned you have the cold case setup &...

saw you mentioned you have the cold case setup & did the clearance check. I would check your tune, air flow and verify temps with a gun.
Forum: Engine / Power / Tuning 10-10-2019, 12:26 PM
Replies: 8
Views: 2,400
Posted By TaKid455
Always felt 1st gens had a small radiator for...

Always felt 1st gens had a small radiator for what you could stuff into them. Just finished up a 67 w/ a healthy 428 for a customer. Did the aluminum rad w/ 16" fan setup. Haven't had any issues....
Forum: Cruisers' Corner / Other Events 09-11-2019, 09:18 PM
Replies: 6
Views: 2,475
Posted By TaKid455
Glad its back. Will try to make it. Worth the...

Glad its back. Will try to make it. Worth the trip.
Forum: Wanted To Buy - Automotive 08-20-2019, 07:30 AM
Replies: 6
Views: 484
Posted By TaKid455
sent PM

sent PM
Forum: Wanted To Buy - Automotive 08-09-2019, 07:40 AM
Replies: 6
Views: 484
Posted By TaKid455
Tripped over a set yesterday. Trying to remember...

Tripped over a set yesterday. Trying to remember if they belong to some one or not. I beleive they are up for grabs.
Forum: Wanted To Buy - Automotive 08-09-2019, 07:37 AM
Replies: 5
Views: 375
Posted By TaKid455
They are different. Olds, Pontiac and chevy are...

They are different. Olds, Pontiac and chevy are all different. Nothing for a chevy that I am aware in stock. You could possibly make one of the others work but may need a fan spacer. For the love...
Forum: Wanted To Buy - Automotive 08-06-2019, 08:02 PM
Replies: 6
Views: 484
Posted By TaKid455
I'll need to check the stock. Got rid of a bunch...

I'll need to check the stock. Got rid of a bunch awhile ago. No driver's tracks but have some pass tracks.
Forum: Wanted To Buy - Automotive 08-06-2019, 07:58 PM
Replies: 5
Views: 375
Posted By TaKid455
I have some used ones and a new OER one. You can...

I have some used ones and a new OER one. You can also get them new from GM. Won't be cost effective to ship
Showing results 1 to 25 of 500

 
Forum Jump
» Sponsor List














All times are GMT -5. The time now is 12:47 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.