Today's Posts Mark Forums Read Calendar
Go Back   NJFBOA - Home of New Jersey's Camaros and Firebirds > Search Forums

Notices


Showing results 1 to 4 of 4
Search took 0.00 seconds.
Search: Posts Made By: V
Forum: Restorations, Fabrication, Tool and Shop Tech 05-02-2013, 12:08 PM
Replies: 47
Views: 4,377
Posted By V
Matt, now put a piece of cardboard inside the...

Matt, now put a piece of cardboard inside the trans tunnel(to cover the trans, and use rustolem spray paint, like flat black grill paint(high heat) and spray from the inside of the car into the hole....
Forum: Restorations, Fabrication, Tool and Shop Tech 03-13-2013, 08:24 PM
Replies: 47
Views: 4,377
Posted By V
a hole saw on curved metal is actually not that...

a hole saw on curved metal is actually not that hard. use a decent pilot drill bit to make the center hole, then use a duller bit that fits in. that way it will be less likely to "walk" or open up...
Forum: Restorations, Fabrication, Tool and Shop Tech 03-13-2013, 01:32 PM
Replies: 47
Views: 4,377
Posted By V
do this... open up trans, remove the connector,...

do this... open up trans, remove the connector, extend the wires, close up trans and run harness in a different place.
Forum: Restorations, Fabrication, Tool and Shop Tech 03-12-2013, 10:11 AM
Replies: 47
Views: 4,377
Posted By V
Have you looked to see if anyone does or can make...

Have you looked to see if anyone does or can make a custom connector? like 90°, then you can run the harness back a little . not a simple mod but shouldn't be impossible. only like 12 pins or...
Showing results 1 to 4 of 4

 
Forum Jump
» Sponsor List














All times are GMT -5. The time now is 01:48 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.