Today's Posts Mark Forums Read Calendar
Go Back   NJFBOA - Home of New Jersey's Camaros and Firebirds > Search Forums

Notices


Showing results 1 to 25 of 500
Search took 0.36 seconds.
Search: Posts Made By: FlyingDutchman
Forum: Transmission and Driveline 05-29-2018, 10:21 PM
Replies: 14
Views: 3,560
Posted By FlyingDutchman
Ditch the roller pilot bearing and get a new...

Ditch the roller pilot bearing and get a new bushing.
Forum: North Jersey 02-27-2018, 02:44 PM
Replies: 1,442
Views: 525,059
Posted By FlyingDutchman
Black 2nd gen trans am on 287 SB near boonton,...

Black 2nd gen trans am on 287 SB near boonton, white letters reading "JET FUEL ONLY"
Forum: Member's Projects 12-28-2017, 08:17 AM
Replies: 486
Views: 79,769
Posted By FlyingDutchman
That's awesome. I really like the torqhead kit...

That's awesome. I really like the torqhead kit and have been considering it, a bit expensive though. Could save some money getting coils and other parts from a junkyard I'm sure, would help if he was...
Forum: General Tech 12-20-2017, 02:54 PM
Replies: 32
Views: 34,442
Posted By FlyingDutchman
P20ee has also been related to DEF tank, which is...

P20ee has also been related to DEF tank, which is covered to 120k miles I think.

What's passenger car diesel inspection for NJ?
Forum: General Tech 12-20-2017, 12:01 PM
Replies: 32
Views: 34,442
Posted By FlyingDutchman
Probably should do that to rule it out - it's a...

Probably should do that to rule it out - it's a recall and cost 0$. Chevrolet's website let's you enter your VIN and see what warranties are valid and what work was done (granted the dealership...
Forum: General Tech 12-19-2017, 08:31 PM
Replies: 32
Views: 34,442
Posted By FlyingDutchman
Was NOx1 replaced and newest tune flashed?

Was NOx1 replaced and newest tune flashed?
Forum: General Tech 11-29-2017, 06:37 AM
Replies: 32
Views: 34,442
Posted By FlyingDutchman
Isn't that sensor covered under warranty? I...

Isn't that sensor covered under warranty? I replaced it myself before it was a known problem (I had persistent P11D7). There was a revised part, maybe check the module and compare with the rockauto...
Forum: The Later Years 93-present 11-07-2017, 03:07 PM
Replies: 181
Views: 53,011
Posted By FlyingDutchman
+1 !

+1 !
Forum: Member's Projects 10-30-2017, 11:01 AM
Replies: 2,509
Views: 891,300
Posted By FlyingDutchman
You can be a tooth off and it will run albeit...

You can be a tooth off and it will run albeit poorly and noticeable. How long did it run? Just once, backfire, die within a few seconds?
Forum: Member's Projects 10-30-2017, 09:32 AM
Replies: 2,509
Views: 891,300
Posted By FlyingDutchman
Well you don't have an opti to fail and it's...

Well you don't have an opti to fail and it's nearly impossible to cross your plug wires (not sure about coil harness, maybe verify that). You're positive the crank and cam are lined up right? New or...
Forum: Member's Projects 10-29-2017, 05:41 PM
Replies: 2,509
Views: 891,300
Posted By FlyingDutchman
By "no signs of firing" does this include having...

By "no signs of firing" does this include having no spark?
Forum: General Tech 10-24-2017, 07:43 PM
Replies: 38
Views: 30,174
Posted By FlyingDutchman
I swapped a Delphi unit in last fall, I haven't...

I swapped a Delphi unit in last fall, I haven't had a problem. Got it off rockauto. I was having long crank times, thought it was from the airtex that was installed, but after resealing the manifold...
Forum: Member's Projects 10-10-2017, 11:25 AM
Replies: 2,509
Views: 891,300
Posted By FlyingDutchman
Suspension has to be loaded to tilt torque arm...

Suspension has to be loaded to tilt torque arm down/inline with trans, otherwise it will be pinned against the trans tunnel. With the car or rear half on stands, I use the floor jack to raise rear up.
Forum: General Tech 09-27-2017, 08:03 AM
Replies: 40
Views: 33,123
Posted By FlyingDutchman
Why not just leave it at two bolts ?

Why not just leave it at two bolts ?
Forum: Engine / Power / Tuning 09-25-2017, 01:28 PM
Replies: 29
Views: 29,196
Posted By FlyingDutchman
Who makes the flexplate? For reference, when...

Who makes the flexplate? For reference, when ordering end links for my parents yukon denali, rockauto sent me outer tie rods for an entirely different car despite the acdelco box stating the correct...
Forum: Engine / Power / Tuning 09-19-2017, 07:51 AM
Replies: 12
Views: 15,787
Posted By FlyingDutchman
I had a magnaflow and I liked it. Had a deep...

I had a magnaflow and I liked it. Had a deep rumble at idle and flowed well, but wasn't loud enough for me. I ran it with stock manifolds, then LTs with catted y, then added a cam with it. If I...
Forum: Transmission and Driveline 09-13-2017, 12:32 PM
Replies: 36
Views: 12,388
Posted By FlyingDutchman
I'd be willing to bet the pilot is your issue....

I'd be willing to bet the pilot is your issue. How does the tip of the input shaft look? If the bearing is worn it could be hanging up and not allowing the trans and engine to separate fully (but...
Forum: Transmission and Driveline 08-31-2017, 07:09 AM
Replies: 36
Views: 12,388
Posted By FlyingDutchman
Yeah, if you pretty much ruled out the hydraulics...

Yeah, if you pretty much ruled out the hydraulics there's not much left to play with without pulling the trans out. One other thing I had an issue with was the TOB flange failing and starting to...
Forum: Transmission and Driveline 08-29-2017, 11:42 AM
Replies: 36
Views: 12,388
Posted By FlyingDutchman
Did you check the slave rod isn't bent? I ruined...

Did you check the slave rod isn't bent? I ruined one when it popped out between the bellhousing and clutch fork. Bent it just enough to work but made shifting difficult cause the throw was reduced....
Forum: Transmission and Driveline 08-29-2017, 09:04 AM
Replies: 36
Views: 12,388
Posted By FlyingDutchman
Dumb question, but did you break the rest of the...

Dumb question, but did you break the rest of the strap ? Or leave it partially intact ?
Forum: Brake, Chassis and Suspension Tech 08-23-2017, 07:09 AM
Replies: 11
Views: 4,130
Posted By FlyingDutchman
No big deal. Rock auto has C5 calipers with...

No big deal. Rock auto has C5 calipers with bracket for $70 each. However, if you try to piece it together it may cost more. You'll also need slightly longer flex lines, the rotor adapter, and...
Forum: Brake, Chassis and Suspension Tech 08-22-2017, 05:39 PM
Replies: 11
Views: 4,130
Posted By FlyingDutchman
Do you still have your stock LS calipers?

Do you still have your stock LS calipers?
Forum: Brake, Chassis and Suspension Tech 08-22-2017, 02:31 PM
Replies: 11
Views: 4,130
Posted By FlyingDutchman
As Mike said, I did the C5 brake swap using Kore3...

As Mike said, I did the C5 brake swap using Kore3 conversion. It was well worth the money, no question about that (especially over the LT1 setup). The only real drawback is you have to run a 17"...
Forum: Member's Projects 07-13-2017, 02:53 PM
Replies: 2,509
Views: 891,300
Posted By FlyingDutchman
I resized my rods when I swapped to ARP. It was...

I resized my rods when I swapped to ARP. It was $112 IIRC. I wouldn't skip it personally, it's better to be sure they are round and not distorted trying to remove the old ones or different torque...
Forum: General Tech 07-07-2017, 06:18 PM
Replies: 13
Views: 15,395
Posted By FlyingDutchman
Yes, I get it from my local dealer along with a...

Yes, I get it from my local dealer along with a filter. I could shop it out but it's easier to just swing by. I have yet to see any retailer carry DEXOS2 (blue logo) approved oil.
...
Showing results 1 to 25 of 500

 
Forum Jump
» Sponsor List














All times are GMT -5. The time now is 12:45 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.