[maroman88]

ok i replaced the O2 sensor and the computer still says O2 sensor not ready but no more code 13, i was just reading in my manual that the O2 sensor must reach 600F for it to work and the car runs in "open loop" until then, so im guna go let it warm up and see if i can get it to say O2 ready

as for the code 34 with the MAF, i was told that if there is any air leaking in near the MAF sensor it could set it off, i just sealed it all up with some rubber couplings and clamps, so now im guna go disconnect the battery and let it reset and start all over

i was planning on pulling the bulb out of the dash anyway lol