Quote:
|
Originally Posted by TransAm4Life
I recently had my Cut-Out installed in the intermediate pipe right before the rear axle. Im alittle concerned about exhaust temps and the fact that its aimed right at my LCA bracket. I want to run side mounted tip before the rear tire on the Passanger side.
What do you guys think would look better?
3" Angled Turn-Downs (not visible)
Stock "square" Z28 exhaust tip (best clearance, clears car)
3" Slash Cut exhaust tip (Chrome may look dumb)
Im personally leaning towards the square stock tips myself, because they would tuck in better with the body and still get the job done. |
Attached is a pic of how it was done on my car. The previous owner had it done by Mufflex and it's super nice, no third tip to attract unwanted attention from cops, other would racers etc....I wouldn't worry about it dumping under the car...the cutout is illegal anyway so don't sweat the discharge location....
That's my 2 cents, but you will love the cutout. Especially at the strip, you pull up all quiet, then in the burnout box you open that puppy up, make the run, then close it coming down the return road and make everyone go
WTF.....
Chris