NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

V · 04-07-2006, 01:09 PM

Ok, I have a T-5 hydraulic clutch setup, and I need to replace/extend the OEM hose that goes from the master to the slave cylinder on the trans. Its for a custom install and i need to add some length. How would i go about doing this? The oem line is like a hard plastic line and id like to almost just cut it and install a hard metal line to add the length but id have no way to connect the plastic and metal lines. I MAY be able to get/make a hard metal line to replace the entire plastic line itself. My concern is just that i keep the same Inside Diameter of the hose now. Also i dont think that the extended length would affect the clutch operation that much. The vehicle will not be a race car, just a cruiser with a mild 305.
Are there any companies i could contact to have a line made even? any info or advice/help would be appreciated.

04-07-2006, 01:09 PM	#1
V Stalker Join Date: Aug 2004 Posts: 12,083 iTrader: (12)	T5 hydraulic clutch hose Ok, I have a T-5 hydraulic clutch setup, and I need to replace/extend the OEM hose that goes from the master to the slave cylinder on the trans. Its for a custom install and i need to add some length. How would i go about doing this? The oem line is like a hard plastic line and id like to almost just cut it and install a hard metal line to add the length but id have no way to connect the plastic and metal lines. I MAY be able to get/make a hard metal line to replace the entire plastic line itself. My concern is just that i keep the same Inside Diameter of the hose now. Also i dont think that the extended length would affect the clutch operation that much. The vehicle will not be a race car, just a cruiser with a mild 305. Are there any companies i could contact to have a line made even? any info or advice/help would be appreciated.