View Single Post
Old 04-30-2006, 09:00 AM   #4
johnjzjz
.
 
johnjzjz's Avatar
 
Join Date: Feb 2006
Posts: 1,385
iTrader: (0)
motor cycles have the same problem we have found a real easy way to empty all the air from the master if you have a hand pump oil can clean it real good flush some brake fluid through it conect a small hose that will fit on the slave bleeder on bell housing and pump the fluid from the bottom of the car up to the master and fill it that way if some one is helping you do not let them look into master as you pump ( an eye full ) than we call it slap the clutch pedel at the top 3 inches the sharp banging the pedel will do at the top against the stop will get any small air that was trapped you did not get with the OIL can -- all of this with master top on if you peek you will see air bubbles but watch out for the cars paint it will not like it keep water hose handy jz
johnjzjz is offline   Reply With Quote