[SPRYN4LOWETS]

Thanks JR1, we have moroso upper and lower motor mounts on it. I am thinking its an outter tie rod. I will likely replace them with edquay rod end tie rods to get rid of the toe in while the front end is up. Are your lca's chrmo or mild steel? I see that the lower mounts are mig welded on to it. I planned on doing it the same as you have it. How much droop should i look for when i weld the upper tabs up? Im going to do the limiters and try launching at a lower rpm around 3500 and see how it goes. After i get it straightened out ill pull the limiters and turn the launch rpm back up and let her fly again for some photos.