View Single Post
Old 11-12-2006, 11:34 PM   #3
vegaken
9 Second Club
 
vegaken's Avatar
 
Join Date: Jul 2006
Posts: 114
iTrader: (0)
I have a set of Koni's up front and QA1 out back. They are both single adjustable setups. The springs up front are AFCO 225lbs. and stock height the rear springs are Hypercoil 5 diameter springs with 100lbs. and 13 inch height. I have it setup so I can adjust the spring heights similar to a coil over with the weight jack screws under the rear springs. I might just need to put in a good anti-roll bar in the car over the winter. I am going to call BMR up tomorrow and pick there brains for a little information. If this was a 4 link car it would be a easier for me to get it set. Hopefully get another Friday with some decent temps and I will take another Friday as I few left to burn.
vegaken is offline   Reply With Quote