NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

keith2717 · 11-30-2007, 08:27 AM

Ok, I started getting my stuff. My first shipment came in:
MSD 6AL, MSD Adapter harness, A/C Delete pully, March under drive pullies and MSD 8.5 wires.
I decided to go with a different set of heads.
So my questions are: (Im using the stock reman block, not sure of the specs)
1.What heads do I go with
2. Should I swap the cam out two since I'll have the top end off and I already have the front off. What cam do I go with/
3.Rear, what gear do I go with and who is good that does it.
4. Stall converter what is recomended
5. Intake manifold and runners, what works best.
Remember Im new at this so I might be all over the place so I need guidence
or a build sheet that I can compare to or get inspired by.
Objective is to start drag racing in the 12's to start out with in a competion
based setting.
Thanks
Any and all info would be great.

11-30-2007, 08:27 AM	#1
keith2717 Join Date: Nov 2007 Posts: 165 iTrader: (0)	Project Iroc Ok, I started getting my stuff. My first shipment came in: MSD 6AL, MSD Adapter harness, A/C Delete pully, March under drive pullies and MSD 8.5 wires. I decided to go with a different set of heads. So my questions are: (Im using the stock reman block, not sure of the specs) 1.What heads do I go with 2. Should I swap the cam out two since I'll have the top end off and I already have the front off. What cam do I go with/ 3.Rear, what gear do I go with and who is good that does it. 4. Stall converter what is recomended 5. Intake manifold and runners, what works best. Remember Im new at this so I might be all over the place so I need guidence or a build sheet that I can compare to or get inspired by. Objective is to start drag racing in the 12's to start out with in a competion based setting. Thanks Any and all info would be great.