View Single Post
Old 12-03-2007, 11:22 AM   #1
68pont455
10 Second Club
 
68pont455's Avatar
 
Join Date: Jul 2007
Location: quakertown pa
Posts: 83
iTrader: (0)
piston to valve clearance recommendations

i run a traditional pontiac engine with flat top pistons and steel rods. i had the heads milled so now i am interested in knowing what others are running and if there have been any problems with tight clearances. what clearances for piston to valve does anyone run out there. i have read different ideas on the net and have asked two separate pontiac engine builders and every one has a different idea. what is anyone out there running if you would care to divulge that info in this forum
__________________
Zac Carr
68pont455 is offline   Reply With Quote