NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post - Drilling and Taping the crank for a balancer.

JSPERFORMANCE · 02-19-2008, 07:26 AM

A machine shop is most likely not going to do the job without pulling the crank they will want to install the crank in a holding fixture or maybe use a lathe to drill the hole. If you are trying to do this without dissasembly you will probably have to do it yourself.

02-19-2008, 07:26 AM	#6
JSPERFORMANCE NJFBOA Supporting Sponsor Join Date: Feb 2006 Location: HULMEVILLE, PA Posts: 2,023 iTrader: (4) Social Networks:	A machine shop is most likely not going to do the job without pulling the crank they will want to install the crank in a holding fixture or maybe use a lathe to drill the hole. If you are trying to do this without dissasembly you will probably have to do it yourself. __________________ JSSPEEDANDCUSTOM.COM