NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post - Diagram to dremel a hole in floor for FGuel Pump Access??

Teds89IROC · 03-26-2008, 10:36 PM

Heres the work me and Alex did on my car:

I already went through the hassle of dropping the rear and tank twice, but not only did I not feel like going through it again in the rain, but like Alex, I have a welded y-pipe now so it would clearly be more of a problem than before. Also, it's an aftermarket walbro pump, so I'm sure I will have great use of this access panel time and time again.

EDIT: we used electric sheers, after measuring and masking we had it cut out in 5 minutes.

03-26-2008, 10:36 PM	#29
Teds89IROC Join Date: Sep 2004 Location: Haledon, NJ Posts: 5,162 iTrader: (0)	Heres the work me and Alex did on my car: I already went through the hassle of dropping the rear and tank twice, but not only did I not feel like going through it again in the rain, but like Alex, I have a welded y-pipe now so it would clearly be more of a problem than before. Also, it's an aftermarket walbro pump, so I'm sure I will have great use of this access panel time and time again. EDIT: we used electric sheers, after measuring and masking we had it cut out in 5 minutes. __________________ 1989 IROC-Z 355 LT1 T56 Swapped 2016 Chevy Colorado LT 3.6 v6 2008 Jeep Grand Cherokee Laredo 4.7L RIP 12/29/2016 1998 Honda CBR 600F3 2003 Yamaha FX140 Last edited by Teds89IROC; 03-26-2008 at 10:41 PM.