NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post - Corporate 8.5" 10 bolt....W/ all the goodies.

FAST Z · 04-03-2008, 12:11 AM

I have a shortened up Corporate 8.5" 10 bolt. Not real short like 2"s per side. I run a 15x12 rim with 7.5 back space. Just about everything in it is Mark WIlliams. 33 spline axles, Spool, Has that Moser housing cover, Big ford ends on the axle tubes, Axles tubes are welded in and the rear is all braced and supported up. Set up for ladderbars, has coilover mounts, and Wheelie Bar mounts too.... Needs ring and pinion. Oh, Mark WIlliams Yolk as well. Billet. Yolk alone was 200.bucks.....650.00 takes the whole thing.... just like it is. Has little tie down deals welded to it to for trailering. Pretty trick 10bolt if your into them.. I have been for a long time, Just really realizing I am making just a little bit too much for it. ..ring gear just doesn't like big H.P. blocks on spray....

04-03-2008, 12:11 AM	#1
FAST Z Join Date: Sep 2006 Location: Hamilton Posts: 23 iTrader: (1)	Corporate 8.5" 10 bolt....W/ all the goodies. I have a shortened up Corporate 8.5" 10 bolt. Not real short like 2"s per side. I run a 15x12 rim with 7.5 back space. Just about everything in it is Mark WIlliams. 33 spline axles, Spool, Has that Moser housing cover, Big ford ends on the axle tubes, Axles tubes are welded in and the rear is all braced and supported up. Set up for ladderbars, has coilover mounts, and Wheelie Bar mounts too.... Needs ring and pinion. Oh, Mark WIlliams Yolk as well. Billet. Yolk alone was 200.bucks.....650.00 takes the whole thing.... just like it is. Has little tie down deals welded to it to for trailering. Pretty trick 10bolt if your into them.. I have been for a long time, Just really realizing I am making just a little bit too much for it. ..ring gear just doesn't like big H.P. blocks on spray....