Quote:
Originally Posted by //<86TA>\\
i tried to make a exhaust vid, i knocked my camera over... 
i posted this before on TGO, but how did you get 2nd gen headers on that? got picks from underneath and side? |
well a hot torch and a really big hammer, was good to have, I had to pull the dizzy and lift the motor about 9in. then I had to make some kind of wacky ass Y pipe because the headers were only 8in from the cross member so I need to have a custom Y and cross member made and I need to make more "clearance" (AKA hammertime) I'll post up pics when I do the started sometime today.... they ave VERY tight but they are much longer than 3rd gen LTs so I'd imaging that would help in the torque area.