[JerzyIroc]

engine 305 ho

username (juan) was changing his water pump last night. on the new pump there is a plug on top that you have to take out and put the nipple from the old pump where that plug was. the hose that goes on there goes to the heater core. well the plug is stripped and can't get the plug out. i told him to just bypass the heater core. now obviously he can just leave the plug i. but what about the other hose from the heater core to the motor? wat can he use to cap off the motor side where the hose goes to ? i know he can just take a small hose and just run it from one side to the other on the firewall side to cap the heater core. but what can he use to block off where the other hose is going? i wont be able to take a look at the car til later but does anyone has any ideas so i can just do it quick?