NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post - S-10 with 406 SBC 11:1 TH400 Fast and cheap!

zoomin iroc · 05-19-2008, 11:47 PM

It's a gm 10-bolt, If I remember right it's a 3.73:1. It' open too !!!! Not sure if it was a posi at some point but if you do a burnout and heat the rear tire when you launch it will spin them both. The problem with this is massive wheel hop. I was going to put a new posi unit in it and add a set off lift bars from south side machine. It would probably run 11's if it could hook up off the line. No mater though as going 12's got me thrown off the track (Island Dragway) I used to dial in at 13.00 flat and sandbag. Tons of wins and a bunch of trophies. To be honest I didn't want it to be faster. It is SCARY on the street.

05-19-2008, 11:47 PM	#5
zoomin iroc Join Date: Apr 2005 Location: Jersey Posts: 57 iTrader: (1)	It's a gm 10-bolt, If I remember right it's a 3.73:1. It' open too !!!! Not sure if it was a posi at some point but if you do a burnout and heat the rear tire when you launch it will spin them both. The problem with this is massive wheel hop. I was going to put a new posi unit in it and add a set off lift bars from south side machine. It would probably run 11's if it could hook up off the line. No mater though as going 12's got me thrown off the track (Island Dragway) I used to dial in at 13.00 flat and sandbag. Tons of wins and a bunch of trophies. To be honest I didn't want it to be faster. It is SCARY on the street. __________________ I may be fat and old but I kept my hair and I kept my IROC www.Corvetteplenum.com Last edited by Tru2Chevy; 05-20-2008 at 05:02 PM. Reason: Street Racing Reference