View Single Post
Old 10-10-2008, 07:24 AM   #3
68pont455
10 Second Club
 
68pont455's Avatar
 
Join Date: Jul 2007
Location: quakertown pa
Posts: 83
iTrader: (0)
i could go with the 4 or 4.25 stroke at this point doesnt matter. block is at the 4.31 bore and done up for assemble. i have not obtained the rotating assemble yet so i figured i would check out opinions on the subject. if rod stroke ratio is not as critical to overall longevity and performance i will go with the 4.25 stroke and get the 496 cube motor vs the 4.00 stroke 467 cube motor. i have always heard "no replacemnt for displacement" but after reading some engine builders tech notes i thought i would get some more info on the subject before i make a decision. rod length will be 6.385 so its just a matter of stroke at this point.
__________________
Zac Carr
68pont455 is offline   Reply With Quote