Thread: Header Gasket
View Single Post
Old 05-26-2009, 12:18 PM   #22
Formulalt1
 
Formulalt1's Avatar
 
Join Date: Aug 2005
Location: Lakewood
Posts: 452
iTrader: (3)
I did mine on stands as well but a easy trick to get it to slide in easier is sand the inside of the Y (if you have a die grinder and make sure to not take off too much material, that works better) and the outside of the headers and then use some grease. There are usually some little sharp edges and such that make it resist from sliding in all the way.
__________________

Last edited by Formulalt1; 05-26-2009 at 12:19 PM.
Formulalt1 is offline   Reply With Quote