NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post - My Custom Car PC and Vinyl interior build thread (56K Go Away)

rbaksi · 06-21-2009, 10:24 PM

Here's some more progress guys, I'm almost done

I couldn't really stretch the vinyl far enough so I made into separate pieces as best I could. Gauge cluster is done!

Now the DASH - the hard part. I put some fiberglass bondo on it first to create a base. Then I put a few small screws into it towards the plastic so it would hold strong to the dash.

Then I put some regular bondo and went all over it with the dremel. I put on one more layer and finished it with some hand sanding.

Test fit, I know the edges look rough but this isnt the final pic

06-21-2009, 10:24 PM	#5
rbaksi Join Date: Jan 2008 Posts: 62 iTrader: (3)	Here's some more progress guys, I'm almost done I couldn't really stretch the vinyl far enough so I made into separate pieces as best I could. Gauge cluster is done! Now the DASH - the hard part. I put some fiberglass bondo on it first to create a base. Then I put a few small screws into it towards the plastic so it would hold strong to the dash. Then I put some regular bondo and went all over it with the dremel. I put on one more layer and finished it with some hand sanding. Test fit, I know the edges look rough but this isnt the final pic __________________ '95 Trans Am LT1, white with black racing stripe K&N CAI, Flowmaster exhaust, Honeycomb taillights, rebuilt 4L60E CarPC with 9.2" touchscreen, GPS, bluetooth, iTunes and Internet FQuick: http://www.fquick.com/garages/viewvehicle.php?id=13868