[NJ346]

My car and torque arms are pissing me the **** off. Put a 9in in my car about 2 weeks ago. I messed around with my umi non adj. torque for over 4 hrs and came to the conclusion that it just wouldn't fit. Meanwhile, the stock one slips right on and is installed in a matter of 10 minutes. Then last week, I traded away my UMI + a good amount of cash. Tonight I go and try to install the BMR adj. 1 I bought, and it doesn't fit! I'll go out and take a picture in a few. The BMR one was adj. to match the stock one side by side. I was able to hammer it on to the 9in housing(shouldn't have to do), and the holes are about an 1/8in off. WTf, am I doing wrong? At this point I've pissed away so much money on torque arms only to find that stock is the only one that has worked so far.