NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

S.J.SLEEPER · 07-26-2009, 11:58 PM

you need to use a impact, a 3/8 impact gun not a 1/2". or you can take nut off, drop the lick down, use a straight edge punch to make grooves in the bolt where it is conical and is supposed to seat into socket. then reinstall tap with hammer a couple times, reinstall nut while putting pressure with a pry bar of somesort against the tierod to hold it in place in socket then try to tighten nut.

07-26-2009, 11:58 PM	#2
S.J.SLEEPER Join Date: Jul 2009 Location: barnegat nj Posts: 1,340 iTrader: (10)	you need to use a impact, a 3/8 impact gun not a 1/2". or you can take nut off, drop the lick down, use a straight edge punch to make grooves in the bolt where it is conical and is supposed to seat into socket. then reinstall tap with hammer a couple times, reinstall nut while putting pressure with a pry bar of somesort against the tierod to hold it in place in socket then try to tighten nut.