NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

Iroc-z86 · 09-30-2009, 08:03 PM

there is no ses light, been there done that.

ok the problem is with the abs fuse installed, while braking and under 15 mph the abs activates and kicks back like it should but the problem is it does it on dry roads, very light braking or hard it doesnt matter. every time there i apply the brakes and it slows under 10-15mph the abs kicks in. so i did a little reading and several people said brake pads and shoes replaced them same thing. then wheel sensors aka abs sensors replaced them same thing.

So i need an actual scanner that will read each sensor and find out what is causing the abs system to engage every time i apply the brakes to stop.

oh almost forgot, if i pull the abs fuse the problem goes away and the truck brakes normally... without abs tho.

09-30-2009, 08:03 PM	#4
Iroc-z86 Join Date: Oct 2006 Posts: 929 iTrader: (5)	there is no ses light, been there done that. ok the problem is with the abs fuse installed, while braking and under 15 mph the abs activates and kicks back like it should but the problem is it does it on dry roads, very light braking or hard it doesnt matter. every time there i apply the brakes and it slows under 10-15mph the abs kicks in. so i did a little reading and several people said brake pads and shoes replaced them same thing. then wheel sensors aka abs sensors replaced them same thing. So i need an actual scanner that will read each sensor and find out what is causing the abs system to engage every time i apply the brakes to stop. oh almost forgot, if i pull the abs fuse the problem goes away and the truck brakes normally... without abs tho. __________________ 1986 IROC-Z - 305- .030 over, Voodoo cam, 113 vette heads, tpi, hedman torque steps, GMMG 3in catback, custom chip, t56, 3.27s 9 bolt, rest of the car is stock. 2011 Camaro - 2lt/rs red jewel tincoat, m6 - SOLD 2014 Camaro SS - bolt ons 1998 Jimmy - the beater Last edited by Iroc-z86; 09-30-2009 at 08:04 PM.