[HardcoreZ28]

I'm finishing up a bathroom remodel at my house and need to use a table saw to make 4 quick cuts. The area where my vanity goes has a wall that isn't straight. The vanity opening is 30" however the wall leading into it is slightly smaller at 29.5". Either I could tear the wall down and fix it now that it's already been painted (I didn't put the wall up)...or I can just shave a quarter inch off each leg of the vanity and have a small gap between it and the wall on each side once it's installed.

The legs extend about a half inch past each side and are only about 1.5" wide so I need to just shave that small piece off of each of the 4 legs but rather use a table saw instead of trying my hand a cutting it straight with a circular saw.

Anyone in the Somerset or Mercer County area have one and willing to let me run over with the vanity and cut it quick?