|
lots of stuff FS LTCC, 95PCM...
id really like to clear some of this stuff out of the garage its in the way at this point offer $$ and theres a good chance ill take it except on the headers.
slp coated mid tube headers and ory have emission fittings were priced about 900 new-sold
-complete stock rear suspension torque arm, panhard rod, sway bar, lca's-$80
-lt1 front brakes spindles hub caliper rotors-$70
-stock steel DS-$80
-stock fuel injectors-best offer dont kow the going rate
-165k mile lt1 shortblock with pan and oil pump. missing a few sensors-$300?
-have some things out of the stock motor like lifters lifter hold down pushrods rockers all factory
-i also have a ltcc kit you'll need the coil packs i'll be using the ones i have-$250
-lt1 pcm and engine harness-$150+shipping harness may have 1-2 snipped wires(oil pan sensor)
-10 bolt out of a 3rd gen with drum brakes and a brand new eaton posi-$150
__________________
95 camaro z28 six speed 13.1 @ 106mph N/A
slp mid tubes, hooker 3" cat back with cut out, moroso cai, holly 58mm tb, eibach drag launch springs, kyb agx shocks, lakewood lca's, brand x 100 shot
stroker build this winter
|