View Single Post
Old 03-23-2010, 12:32 AM   #5
IROCZman15
10 Second Club / Meet Coordinator
 
IROCZman15's Avatar
 
Join Date: Dec 2004
Location: Roxbury, NJ
Posts: 2,136
iTrader: (8)
Quote:
Originally Posted by B4C View Post
Looks god but I've heard bad things about por 15 and clean metal.


yea i read a few articles on various forums about that too.. so i went to the POR headquarters in whippany, NJ and got the raw deal and a verbal promise that it will hold up. it it flakes...its ok. if it bubbles near the cut out.. im ok. i was told they would take care of me

i mean the goal i was going for was the rustproofing and scraping off the nasty old undercoating to see any areas that were starting to get rust spots; the POR15 is better then the factory rubberized or wax undercoating from 24 years ago which had since turned into some ridiculous nasty grime covered mushy coating.


btw...

for you NJFBOA guys
the POR 15 office is located in Whippany/Morristown NJ and you can walk right in
__________________
1987 IROC-Z - modified


Last edited by IROCZman15; 03-24-2010 at 07:21 AM.
IROCZman15 is offline   Reply With Quote