[nj85z28]

Unfortunately with being out of work for so long I cant afford to do what I wanted to do with my monte carlo ss. then i decided to part it out and keep the engine for an eventual 3rd gen project, but the way things are looking right now that wont happen for a very long time either. I think its best to sell my drivetrain as much as I dont want to.


Engine built by JS Performance- Here is the spec sheet he provided

Engine has about 2500 miles on it.

355 sbc
3970010 casting
4.030 bore
honed with torque plate
line honed
deck milled .020
durabond cam bearings
new freeze plugs
screw in oil galley plugs
blueprinted and assembled
gm crank cut .010 and polished
trw forged flat top pistons
trw moly ring set
scat I beam connecting rods w/ arp bolts
king rod and main bearings
pioneer 153 tooth flex plate
pioneer 6" balancer
trw pins pressed on and rotating assembly balanced
howards hydraulic roller cam
speed pro hydraulic roller linked lifters
sa double roller timing set
melling HV oil pump and pickup
comp prod cam button and retainer plate
fel pro gaskets and seals

Heads-
882 casting
1.94 intake valves 1.5 exhaust
bronze guides
pocket ported
surface milled
machined for pc seals
assembed with new springs and retainers
comp prod. valve spring and retainer set
comp cams push rods
elgin 1.5 ratio roller tip rocker arm set
cometic MLS head gaskets
VTO valve seals


Also has a new 88 Vette distributor

Asking $4000 obo for the engine....
comes with all the paperwork from JS

Engine comes with TPI computer, and would be ready to drop in your car and go.





Trans- about 3500 miles
700R4
Built by Level10 in McAffee, NJ
PTS Transmission
PTS Torque converter

Should still be under warranty
(have receipts but are very vague as you can see)

was 3800 new..
asking $1800 obo