Quote:
Originally Posted by KirkEvil
Trans Line Fittings
This was my thread on dealing with the trans lines and fittings. I measured the OD of the lines to be 0.315"
|
Thanks for the link. Good info.
I think I will just flare the lines where they get cut off (near the cross member), and bend over a a 90 degree angle toward the passenger side. That way the flare will make for a tight seal, and the hoses can't blow off. Anyway, that's what B&M says to do.
Advance has the flair tool and benders for just a few bucks. Will check them out when I get the poly bushings.