NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post - Question - Adapting Rear 3-Point Seat Belts to an Older Car...

The Fixer · 05-31-2010, 09:39 AM

Thanks for the suggestions guys! I think I'm going to bend the washer for now - my brother-in-law has a bench vise, so I'll put the wide side in and bend the short side. Eventually I may add an extra plate underneath it too Scott - I like that idea, but there's not a lot of space back there to work, and the shelf has a funny contour to it.

05-31-2010, 09:39 AM	#5
The Fixer Join Date: Aug 2004 Location: North Jersey Posts: 3,047 iTrader: (5)	Thanks for the suggestions guys! I think I'm going to bend the washer for now - my brother-in-law has a bench vise, so I'll put the wide side in and bend the short side. Eventually I may add an extra plate underneath it too Scott - I like that idea, but there's not a lot of space back there to work, and the shelf has a funny contour to it. __________________ Seeya, Steve R. in North Jersey '16 Go-Mango Dodge Charger R/T. It's so good to be back in a V8-powered, RWD car! Former Toy - '88 Monte SS - had lots of mods...