ok so i test fit my big and littles today to measure how long of studs i need. Now im still on the stock stud size of 12x1.5 thread width, which i think is fine for my power range. im going to need to go longer in the front which i already know (2.5" for the fronts) but my question is about the rears. I have a strange 12 bolt and they must put longer studs in to begin with because they stick out much longer than the fronts when the wheels are on. Now the stud width is roughly 1/2 inch and im only showing just a scouch above 3/8's of an inch that will enter the hexed portion of the lug. Will this be sufficient or do i have to get longer studs for the extra 1/8 inch? Keep in mind in the rear i will be using a 3/4" shank lug as opposed to the 1/2" the front requires. here is a pic with the wheel tightened down with one lug removed, but will the washer on to show how much thread enters the hexed portion.
tell me what you think... sorry for the novel i wrote hah