Didn get a chance to post this before the NATS, but i got asked about it and i figure i post up some thing on it.
Spoiler- on Friday (10/22) i took off the stock spoiler and desides to try to swing the duck tail.
I used a 69 Camaro Spoiler- cut out section to shorten it-Angled it slightly to flow with the hatch. Angle was back and inward.
Fiberglass- and primer...
Now to finish it i will sand it all down smooth-but i want to mold it into the rear hatch itself-paint it black to match and maybe paint Trans AM on the Back... for the sides i will add a lil fiberglass to square off the ends a bit- but i like it raised a bit.
Either way I think it came out ok-deff change the look of the rear
Next on the TODO LIST...
Front Bumper / Fiberglass spoiler
Side Skirts / Fiberglass - molding for Tips
Side Exhaust
Guages / Install
Roll Bar / Subframe
Then i am done, for a while...lol