Bought these within the last few weeks. . . . looking to get them milled down and checked for cracks and the valve seats redone if needed. I dont think it is going to need vavles, hopefully not. But i have been thinking about getting them CNC'd. . . . . . but not sure where i can get it done
if that does not work i am going to do the porting, very basic just spray the special paint in and just grind it down maybe a few times to clean the ports up. But still get them checked and milled. Anyone have good epxeriences in NNJ with any local machine shops?
How much do you guys predict it costing to get them checked and milled?
And how much does it run for most CNC work
the first picture is after a light cleaning with break cleaner
