View Single Post
Old 11-29-2010, 11:58 AM   #4
transamws686
 
Join Date: Oct 2004
Location: Hillsdale, NJ
Posts: 168
iTrader: (0)
TH400 - $200
Non-tilt steering column blash $75
Cowl panel screen - $10
Wiper switch - $15
"Y" defrost duct $40
Door jam vents $5
Hood hinges $15 each
Window Trim $40 (have front and rear)
Metal panel that goes over the trunk under the rear window $
Cig lighter $10
Dash board brace under steering wheel $10
Dash vents $5
Glove box $20
Driver side air duct $20
Passenger side air duct $20 ea
Side marker light bezels $10 ea
Side marker lights $15
79-81 Rear tail light section and gas tank door $50
Whiper arms - $20 ea
Driver fender $100
Master cylinder, Brake boster $50
used sail panel red dyed black - $50
roof trim non t-top 2 plastic y-pieces and the front and back metal $100
upper seat belt covers, $50
Driver side arm rest $25
79-81 Front bumber, metal, head lights, pontiac emblem, etc, just need to bolt up to car $200
RTS dash emblem $20 each
78 Air cleaner assembly $150 From a 400 (bought it from a member here)
75 shaker scoop part of base craked off and is cut out, $40
Seat track trim plate $10 ea
power window covers $20 ea
inner door plastic hndle trim
Bezels that go around the gauges
if you need a part ask I may have it. make offers
__________________
1998 Transam Chameleon -- SOLD
1981 Trans am Pontiac 400, TH350 -In progress
Bored .060 over, speed pro forged pistons, cat H braun rods, STOCK CRANK CUT .010 .010, ROLLER timing chain, melling 60lb oil pum, comp lifters, comp push rods .080 wall, speed pro molly rings, #62 heads fully ported, stainless valves 2.11X1.77,comp springs and retainers, clevitte bearings, Melling SPC-7 camshaft RAIII, QJ carb 700 cfm
transamws686 is offline