NJFBOA - Home of New Jersey's Camaros and Firebirds - View Single Post

V · 04-30-2011, 06:49 PM

quick question, the filament thats getting power for the DRL... is it the high beam or low beam?

i have a 2011 Cruze and from what i've been reading, the high beam filament is the one that gets the low voltage to be the DRL(its a dual filament bulb, which i assume tha camaro is too) In that case, you should be able to run the HIDs as the low beam wiht out any issues since the high beams will be unplugged basically, but if using a hid/hi beam bulb you can still run it but wire the high beam off a relay setup(exact setup would still need to be figured out but very doable) ill eventually look into it on my Cruze and whatever works for me, should work for you.

04-30-2011, 06:49 PM	#8
V Stalker Join Date: Aug 2004 Posts: 12,082 iTrader: (12)	quick question, the filament thats getting power for the DRL... is it the high beam or low beam? i have a 2011 Cruze and from what i've been reading, the high beam filament is the one that gets the low voltage to be the DRL(its a dual filament bulb, which i assume tha camaro is too) In that case, you should be able to run the HIDs as the low beam wiht out any issues since the high beams will be unplugged basically, but if using a hid/hi beam bulb you can still run it but wire the high beam off a relay setup(exact setup would still need to be figured out but very doable) ill eventually look into it on my Cruze and whatever works for me, should work for you.