Quote:
Originally Posted by WildBillyT
I owned a 350 that had been bored .030 over in one hole.
|
Scary stuff. Seems like a hack job to me. I used to rebuild engines for a chrysler shop. It was a turn & burn shop cranking out rebuilt K-car 2.2L and 2.5L (and the occasional mitsu 2.6) 4-bangers, but even they would never have never let me do this.
Quote:
Originally Posted by Frosty
I've seen some scary stuff come out of Jasper, almost as scary as the car I posted here  |
Maybe they figure that the likelihood of a balancing issue causing a problem in a street car is so small that it doesn't justify boring 7 extra holes. On the other hand, if they are replacing pistons anyways, its just the machinist's labor cost.
It's a cheapskate, penny-pinching hack move if you ask me, especially for a company like Jasper that, presumably, has in-house machine shop.
Quote:
Originally Posted by sweetbmxrider
I like that shift nob.
|
I just caught this. Is that an Xbox controller?