seats now installed in the car:
fully slid back to the rear:
they don't stay that far back. i keep them slid up a few inches more...for a normal look, but they slide fornt/back enough that a person could actually fit in the back seat
drivers side view
from the trunk:
again.. ** THESE SEATS WILL NOT DIRECTLY BOLT IN.. you either have to build your own brackets... or modify your original stock sliders.. if you modify your stock brackets/sliders... the seats will probably hit the roof.. since they are so much taller.
they are comfortable but not as soft/comfy as the old ones.. which is fine. these have the side-bolsters that actually keep you seated in place when you corner hard too.
the only thing I need to do is throw a few 1/4" spacers under the drivers side seat so that it is exactly the same height as the passenger side seat..
-the other thing I need to look into is for a shoulder-area seat belt guide.. you know. that triangle plastic piece that sets the height of the belt by your shoulder. I do NOT want to use the stock ones.. they are very large and obtrusive. I'm looking for something sleek and clean looking. It can be from any make/model vehicle.. I'll find a way to mount it if it looks good.
anyone know of any seat belt guide/retainers by any chance?