Quote:
Originally Posted by S.J.SLEEPER
kinda hard to explain.....
measure the width & height of total opening (pretend split in flange wasnt there)
say its 2" x 4"
total linear length is 12" (if you were to add all sides)
12" divided by 3.14 (pie) = 3.82"
so.... you need to have a 3.82" round pipe (that you would heat & form to a square to fit flange)
if your using 2.5" pipes from manifold..that equals 5" pipe, you need to cut wedge of each pipe to merge them togetherforming a 3.82" pipe.
so doing math again you would need to take off a 1.88 linear inches off each pipe at which ever angle the 2 pipes are merging together.
tip: always best to build merge first and work your way back towards manifolds with pipping
|
Quote:
Originally Posted by S.J.SLEEPER
if you havent made one or bought a t4 flange yet, I can fab you up one this weekend out of stainless.
|
ya know i was just going to heat and form it into a square but i figured that was not how it should be done lol doesnt seem to hard anymore
and thanks for the offer but i already got all my stuff lol
so now plan is like this
1. make t4 merge
2. make the v-band connections for the manifolds
3. connect them